SEM 126C/2 User Manual download pdf (Page 8)

THERMAL OVERLOAD CUT-OUT

The shredder is protected against excessive current draw with a built-in circuit breaker. Should the shredding

unit overheat; the thermal overload device will automatically de-energize the machine. Should this occur, allow

a brief cool down period, then press the red reset button on the back of the machine. When this button stays in

without popping out, you are again ready to start shredding.

 For shredders that have an automatic oiler, the shredder will automatically draw shredder oil during the

operation of the shredder.

LUBRICATION

Important: To prevent jamming and/or clogging of the shredder cutting head, it is necessary to periodically

lubricate the cutting unit. The following procedure is simple and only takes about (30) seconds.

Locate the forward button for the shredder and the “plus” (+) and “minus” (-) buttons for the auto-oiler on the

top cover of the shredder.

Depress and hold the “plus” (+) and “minus” (-) buttons of the auto-oiler and the forward shredding button

simultaneously. This will begin priming the auto-oiler, you will then see the oil going through the yellow

tubing; continue to hold these buttons down until oil has gone the entire length of the tubing. Once completed,

your oiler is primed and ready to go.

MAINTENANCE

Two to three preventative maintenance calls per year are recommended. Only authorized service personnel

should be allowed to service the shredder.

Important: Always unplug the shredder prior to performing any maintenance. If the shredding capacity drops or

should the shredder jam easily, clean and lubricate the cutting system as outlined in the “Lubrication” section of

this manual.

Preventative Maintenance Contracts: Check with your SEM sales representative for the maintenance

requirements to fit your needs at 800-225-9293.

SPECIFICATIONS

Shred Size: 0.7 mm x 4.2 mm Voltage: 120V/1/60Hz, 20 amp dedicated line required.

No. of Sheets: Up to 16 Sheets Controls: Manual or automatic start, stop, and reverse by

Speed: 40 FPM electronic sensors.

Throat Width: 13-3/4” Dimensions: 35-1/2” H x 27-1/2” W x 19-1/4” D

Power: 1-1/2 Hp @ 16 Amps Weight: 300 lbs.

For NATIONWIDE SERVICE call 1(800)225-9293

http://www.monomachines.com

For More Info

Click Here --->

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

SEM 126C/2 User Manual Page 8